MediaMatrix nTouch 180 Manual descargar pdf (Pagina 29)

nTouch 180 Hardware Manual

March 27, 2015 Version 1.7.2.0 25

Note: When you exit the Network Setup screen, you will be prompted to restart the

system. This must be done in order for the settings to take effect.

10. Press Yes to restart the system.

The nTouch 180 will reboot and the new network settings will take effect.

Specifying settings for running Kiosk

If you want Kiosk to start automatically when the nTouch 180 boots up, you must specify a

project name (and optionally, a user name and password). These settings will then be used

automatically.

A project name is also required if you want to start Kiosk manually by exiting the main set up

screen in the touch screen interface. If you specify the project using the touch screen interface,

the Exit button will be available immediately. If you use the web interface, you must firstly

display the project settings in the touch screen interface, then select Exit to refresh the display.

 To specify settings for running Kiosk automatically

1. On the main set up screen, press Project.

2. Press Edit Project.

3. Type the name of the NWare project, and then click OK.

If you do not specify a valid project, the user will be prompted to choose a project when

the unit powers up.

Note: The project name is case-sensitive.

4. Press Edit User.

5. Type the username for the project, and then click OK.

Note: The username is case-sensitive.

6. Press Edit Password.

7. Type the password for the project, and then click OK.

Note: The password is case-sensitive.

8. Press Exit.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 57 58

Sin comentarios

MediaMatrix nTouch 180 Manual Pagina 29